Ford Ecosport Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Help anyone, The door seal seems to held in place by 2 plastic clips, about inch in length. They have both broken and the seal is now not fitting allowing water and quiet a bit of noise into the cabin. Anyone now where to get a replacement, local ford unable to help at the moment and also probably want to charge me the earth for them.
 

Attachments

·
Registered
Joined
·
816 Posts
Not quite sure how they clip on, but until the Ford service departments opens up again to get new ones, do a temporary repair.

My idea of a temporary repair....or come up with your own idea.
you could temporary use some 'twin epoxy glue' similar to araldite (from poundland who are open at obviously a £1) to hold clip in place, and then coat the seal in that area with silicon grease (rs components part number 494-124 from their website, around a fiver £5, I always have a tube of that handy) or get some other make of silicon grease to keep rain water out.

You will be able to wipe the grease off and get the epoxy off the rubber seal later on, and fit the new seal clips. Good luck.
 
1 - 2 of 2 Posts
Top