Ford Ecosport Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
My ecosport came without roof rails. I have sourced a complete pair. I was told that you remove the rubber strip on the car and the bolt holes are there, you just use M6 x 40mm bolts!

However when I just looked - there are dimples in the right place but no holes!!!

Help what do I do next?
Thanks:confused:
 

·
Registered
Joined
·
807 Posts
Hello, that is a good explanation of what we need to know, it does help to understand the question in detail, so we can figure out where you are stuck :D

What you have is four sealed threaded holes on the roof, the dimples, two per side. They are sealed with a mastic and painted over in the factory that dries and has hardened up, so it is weatherproof. These were hidden by the plastic strips which you have now removed.

You need to cut round the mastic at each of the four dimples with a stanley knife (see video, cut round the dimple in a rectangle shape), then peal the mastic off, use a flat edged screwdriver to dig it out. If you think you have exposed any paint (try not to) and see bare metal, then paint it to prevent rusting.

Now you have the four threaded holes for fitting the supplied bolts from the roof rail kit which will be the correct size of thread and then fit the roof rails. I would put some silicon sealant on the top part of the threads under the bolts head when inserting, to make it completely waterproof. Do not overtighten or you may strip the threads. Hope that's you sorted now. Cheers.

Here is a Generic Ford video (not Ecosport) that shows a guy cutting the mastic away, to give you a better idea how to do it....

 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
Hi Colin, thanks so much for your reply. I forgot to mention that I was also lead to believe 'on this forum', but another older thread, that there are 6 bolt to be put in on each side?
Yours
Tom
 
1 - 3 of 3 Posts
Top