Ford Ecosport Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
How do I change the tyre pressure settings from bar to psi on the tyre monitoring display.
 

·
Registered
Joined
·
14 Posts
Hi Ricky,

if you go into the vehicle setting option there are options such as mpg, psi, bar etc. Hope that helps.

Gav
 

·
Registered
Joined
·
1 Posts
Hi, My problem with the Tyre monitor is that even after pumping up tyres and resetting the alarm after about a week it kicks off again , had 2 new front tyres fitted , still does it , if you switch off the monitor it still goes back to main alarm when you start the car up . Any ideas ?
 

·
Registered
Joined
·
853 Posts
Hi Julie and welcome to the forum :D

Either you are not resetting properly or you have a fault with your TPMS reset (Tyre pressure monitoring system) and will have to go to your Ford dealership.

Possible fault could be a tyre sensor acting up as you changed tyres, goto dealership for checking.

 

·
Registered
Joined
·
2 Posts
Julie a couple of things to consider.

Are your actual tyre pressures matching the selected load setting. If the load setting is maximum then you will need to maintain these pressures.

If the issues just started after the tyre change did they put the wheels back on the car in the same position, if not the sensors will be misidentified. These models appear to self re-learning without the tool and need to be driven on a straight road without turning for a couple of miles at 30mph.

Failing that one or more of the sensors may have been damaged during the tyre change.
 
1 - 5 of 5 Posts
Top